7 Machine
Home / Can-Am/BRP

outlander 400 cutting out

dillon2010-08-10 01:36:09 +0000 #1
hey everyone im new here to the forum and got a question about my outlander. it seems when i get water a little over the engine it starts puttering and then cutts off on me.everything on my bike is snorkled and ive got my vent lines ran up any ideas on whats causing the problem????

heres a few pictures of my bike
hondarecoveryman2010-08-10 01:51:13 +0000 #2
Did you seal all your connectors and plug wire with dielectric grease?
dillon2010-08-10 02:09:15 +0000 #3
yea did that when i snorkled it a couple months ago.havent put anymoregrease on them since then though
hondarecoveryman2010-08-10 02:38:19 +0000 #4
Has it been doing this the whole time or just start? Also check your plug wire for cracks and seal up the coil end too with silicone
dillon2010-08-10 02:22:07 +0000 #5
ok ill try sealing up the coil end with silicone tonight and let it dry. nah it started about a month ago
hondarecoveryman2010-08-10 02:56:06 +0000 #6
Prob just a conector somewhere the seal got broken on, Let it idle and spray the connectors with water untill you find the prob
dillon2010-08-10 03:24:52 +0000 #7
ight ill do so thanks for the help



Other posts in this category