7 Machine
Home / Honda

07 rincon rear diff

BUTR KING2010-08-10 07:45:02 +0000 #1
Anyone have a trick to remove the pinion bearing out of the housing on the rear diff.
bump5302010-08-10 07:55:24 +0000 #2
the needle bearing? if so, u have to remove that little wire that u can see in the hole on the case. spin the wire around with a small screw drive and then once u find the ends, pry it up with the screw driver and pull it out with a pair of pliers. then remove all the needles out of the inside and use a blind hole bearing puller to put the bearing race out. or if u dont have the puller, weld a piece of all thread to it, and make u a slide hammer set up. or ur last option would be to take a dremel and grind thru the race in about 2 place and bust it out.

Reply

Name:
Content:


Other posts in this category