7 Machine
Home / Kawasaki


killzone2010-08-11 13:26:41 +0000 #1
Ok.. I have an 07 brute and when i was riding the other day the 4wd quit working on the bike. I got to working on it and i ohm the handlebar switch out and i believe it is good, i put 12v of direct current from a battery to the actuator and you could hear it engage but it didnt show it was in 4wd on the screen but it was becausec i lifted it up and the front tires spun. I then thought it was something in one of the computers. I got the smaller box off (not the igniton) a friends bike and put it on.. nothing different. changed them back off and then put his ignition on (which is a dynatek) and that didnt do anything. but now.. when i put my stock ignition back on not only is the 4wd still not working the belt light is blinking. What are my problems????
IBBruin2010-08-11 13:34:55 +0000 #2
Search 4WD not working. We have tons of threads on that subject.
MeanGreenMan2010-08-11 14:16:11 +0000 #3

Is the meter flashing back and forth between 2WD and 4WD letters?

If yes, the EBC actuator might be bad (4x4 actuator is good as you already checked).

If no, either your igniter or the speedo sensor is bad.

The very first think you should do now is to reset the belt light flashing. Then go from there.
wood butcher2010-08-11 14:32:41 +0000 #4
if the speed sensor has water in it ur 4x4 light will act up. it located under the belt housing where the break pedal mounts to the frame



Other posts in this category