7 Machine
Home / Kawasaki

Took Her Top Off Today !!

Brutetherapy2010-08-11 13:21:08 +0000 #1
Well first thing this morning i woke up to a my girlfriend complaining that i needed to paint the house,build a deck,Pull weeds and mow the lawn

Blah...So i went straight to the barn and locked my self in there. Im slowly getting around to snorking the brute amongst other things. Well i took the front end off and what a mess ! Half of my wires are caked with mud, i have green wires.Its ok to power wash all the mud out as long as the air intake Etc is covered right ? So a few questions..While sitting on the bike,Left side on the front frame is some sort of vent, Should this be in the pod ? Other dielectric grease on all the wires, what else should i do while the plastic is off ? Where is the gas vent ? There is a box that runs in front of the battery maybe behind it ?, the CVT intake ? should i remove this when running MIMB setup ? Who puts these **** things together Robots ? <Ha I hope i can get this thing back together when im done.I bumped the table that all my screws were on, now there all mixed up, but i do have em all, i think.

I guess this is all for today, here are some photos of the mess..

Here is the vent line in question ?










N2Otorious2010-08-11 13:28:52 +0000 #2


The duct on top of the cover is CVT Exhaust, The Front duct of the CVT cover is intake and goes to the right side of the handlebars. On the left side of the handlebars is the engine intake.

216.37.204.203/Kawas...p?Type=13&A=204&B=14
650Brute2010-08-11 13:50:56 +0000 #3
Looks like what mine used ta look like...
Heath0707072010-08-11 14:34:43 +0000 #4
Hey man I would like to see a picture of your bike with those wheels and tires on it
DRZfour002010-08-11 14:16:05 +0000 #5
Where's your springs?
wood butcher2010-08-11 15:12:17 +0000 #6
Quote:

Originally Posted by DRZfour00

Where's your springs?

its a SRA bike, it has front struts not shocks
walker2010-08-11 14:13:12 +0000 #7
where you be living at in tyler?????
N2Otorious2010-08-11 15:14:27 +0000 #8
Quote:

Originally Posted by walker

where you be living at in tyler?????

PM sent.
Brutetherapy2010-08-11 16:03:53 +0000 #9
Ok, guys..Does the side shot look right ? The pipe looks like it sticks out too far,Do i have to cut my plastic( bottom Shroud or what ever its called) ?

Rim Shot.







650Brute2010-08-11 15:00:35 +0000 #10
Can you just turn the assembly coming out of the 3" x 2", then compensate with that 90* near the airbox? and still keep the ends where they need to be?

Side note, mine sticks my plastic out a bit also.
Brutetherapy2010-08-11 14:23:12 +0000 #11
Not sure i can, not in the barn right now but i think the first 45 coming from the 3x2 is touching the frame. Can you get some photos of this side on your brute..Please =). Did you have to cut your front Hood or Fender to fit over the CVT pipe ? I might just order the KFX Cvt boot..

Reply

Name:
Content:


Other posts in this category